Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V

11/29/2023

DV 04:01 PM PCB Development: RE: Pin connection

Hi Mohammad,
You could route a clock from the HPS to the fabric, which is done through the HPS block in qsys. This clock is generated from the on SOM 25Mhz oscillator and is PLLed up to 100Mhz by the HPS. The checkbox is called "Enabl... Daniel Vincelette

11/21/2023

MA 04:59 PM PCB Development: RE: Pin connection

Hello Dan,
Thanks for providing this information and support. According to this datasheet, the FPGA module has an external oscillator. I was wondering if there is any way to enable the internal oscillators to be used because I tried ... Mohammad Hassan Adeli

11/20/2023

DV 06:30 PM PCB Development: RE: Pin connection

Hello Mohammad,
Please take a look at our development board schematic, if you haven't already. It can be found here: https://support.criticallink.com/redmine/projects/5csxbase/wiki/Errata_and_Product_Change_Notifications. *80-000578RC... Daniel Vincelette

11/17/2023

MA 07:38 PM PCB Development: RE: Pin connection

Thanks for your reply, Mike. I used Y13 as the clock pin in the development board and I wonder where internally in the layout of the development kit it is connected.
I want to remove just the FPGA module and use it alone in my project... Mohammad Hassan Adeli

MW 07:30 PM PCB Development: RE: Pin connection

Hi Mohammad,
If you open up the Datasheet and check Table 8 and search for Y13 you should that it is a direct connect to the EDGE connector (I believe pin 117, but you should double check).
There is no other connection.
With reg... Michael Williamson

MA 07:08 PM PCB Development: Pin connection

Hello,
I have a development kit of MitySOM-5csx (https://www.criticallink.com/product/mitysom-5csx-dev-kit/). I was wondering can anyone let me know where the Y13 pin of the FPGA module is connected internally in this board.
Thank... Mohammad Hassan Adeli