Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V

09/09/2020

AB 11:43 PM FPGA Development: RE: Quartus v20.1 errors building mitysom 5csx project

Tristan,
I wanted to let you know that I installed Quartus Lite 20.1 and attempted to build the FPGA project per our Wiki instructions. I got to the same exact point and error as you. It appears, in my case, that if I manually run the... Alexander Block

TA 09:49 PM FPGA Development: RE: Quartus v20.1 errors building mitysom 5csx project

I also get these errors when generating the Platform Designer VHDL:
Info: m0: "fpga_ddr" instantiated altera_mem_if_ddr3_afi_mux "m0"
Error: s0: Error during execution of "{C:/intelfpga/20.1/quartus/../nios2eds/Nios II Command Shell.ba... Tristan Aldinger

TA 09:40 PM FPGA Development: Quartus v20.1 errors building mitysom 5csx project

I am trying to load the provided DEV_5CSX_H6_42A project in Quartus v20.1 Standard and compile the design to insert my own FPGA code.
However, I cannot get past these errors related to the Qsys/Platform designer:
Error (12006): Node... Tristan Aldinger

DV 09:48 PM Software Development: RE: Board bring-up

Hello VJ,
Thank you for pointing out the error with the bsp-editor screen shot on the QSPI wiki page! That should only have BOOT_FROM_QSPI enabled when trying to boot from QSPI. I believe when both are enabled u-boot will try to look ... Daniel Vincelette

09/02/2020

DV 09:38 PM FPGA Development: RE: Quartus Device id for mitySOM 5CSE-H4-3YA-RI-ND

Hello,
The device type is 5CSEBA4U23I7
Dan Daniel Vincelette

PC 09:30 PM FPGA Development: Quartus Device id for mitySOM 5CSE-H4-3YA-RI-ND

What is the device id for Quartus for mitySOM 5CSE-H4-3YA-RI-ND? Pablo Camacho

09/01/2020

VJ 10:49 AM Software Development: RE: Board bring-up

Hi Mike, thank you for your reply.
We have done some testing regarding this and we have figured out that we cannot use the recommendation in https://support.criticallink.com/redmine/projects/mityarm-5cs/wiki/Utilizing_QSPI_NOR_Memory wh... V J

08/26/2020

MW 11:21 AM Software Development: RE: Board bring-up

Hi VJ,
The fact that you are making it to u-Boot (after the SPL) means you are pretty much there!
The bad CRC message (before you saved your environment) means that either:
# the location in QSPI that the uBoot application is lo... Michael Williamson

VJ 10:39 AM Software Development: Board bring-up

Hi
We have recently received 10 MitySOM-5CSX boards, but we have not been able to boot correctly.
Up to now we have been using the evaluation board with included SOM-boards where we have:
- switched from booting from MMC to on-board... V J