Mity CPU Platforms » MityDSP (TI TMS320C6xxx Based Products)

02/08/2012

DB 11:51 AM PCB Development: RE: AUX I/O Connector location dimensions

Thanks Mike,
I have Rev 1/Document Revision: Draft – MityDSP-Pro Rev. B dated Nov 15th 2009 of the design guide and it wasn't in that. I guess there must be a later version. Is the only place to get the documents on the web site were ... Douglas Beumeler

MW 10:58 AM PCB Development: RE: AUX I/O Connector location dimensions

Hi Doug, dorry for the delay.
The information you need should be in the MityDSP-Pro Carrier board design guide, I am attaching a copy of the figure here. Is this what you need?
-Mike
!MityDSP-PRO-Aux_Connector_Location.png! Michael Williamson

DB 10:48 AM PCB Development: RE: AUX I/O Connector location dimensions

I would like to get a reply to my question. I am finishing up my layout and need to place the connector.
Thanks,
Doug Douglas Beumeler

02/03/2012

DB 04:46 PM PCB Development: AUX I/O Connector location dimensions

It is recommended to use the AUX I/O connector on the MityDSP-Pro on carrier board designs but I can't seem to find any documentation on the location of the connector. Please let me know if it is called out in any of the documentation. I... Douglas Beumeler

01/26/2012

BC 01:29 PM FPGA Development: RE: Looking for top-level module for FPGA Hands-on exercise for MDSP-Pro

Oops! I see it there. Thanks, Mike. That'll work. Bob Clarke

MW 12:51 PM FPGA Development: RE: Looking for top-level module for FPGA Hands-on exercise for MDSP-Pro

Hi Bob,
Is it not included in the hdl.zip download file? (pulse_gen.vhdl)
-Mike
Michael Williamson

BC 12:48 PM FPGA Development: Looking for top-level module for FPGA Hands-on exercise for MDSP-Pro

Is it possible to get the "answer" top-level module for the MDSP Training Day 1: MityDSP FPGA – Hands-on exercise?
This would be very helpful for me in creating my own module for the MityDSP-Pro.
Thanks.
-Bob Clarke Bob Clarke