Activity
From 09/03/2015 to 10/02/2015
09/03/2015
- MF 11:55 AM Software Development: RE: Create ubifs
- My mistake... misstyped MLO load addresses (0x4000 instead of 0x40000).
Started over an loaded everything from the UART boot. Successfully. - JC 10:03 AM Software Development: RE: Create ubifs
- Mary Frantz wrote:
> So, of course, after reloading MLO and u-boot.img to get the console log....it boots from NAND.
Go figure. Glad you got it working. If your going to be flashing a bunch of units over UART, you may want to update... - JC 09:58 AM Software Development: RE: Create ubifs
- Ran the same commands on our board and was able to boot from nand. Note that I didn't boot from UART but this shouldn't matter.
I started from a newer u-boot version but there doesn't appear to be any relevant changes between your ver... - MF 09:48 AM Software Development: RE: Create ubifs
- So, of course, after reloading MLO and u-boot.img to get the console log....it boots from NAND.
- MF 09:30 AM Software Development: RE: Create ubifs
- See attached console log file.
Yes. I did the following: - JC 08:58 AM Software Development: RE: Create ubifs
- Right, I forgot that they were inverted.
I'm not seeing anything wrong in what you posted, could you provide the console log when you program it?
Also when you rebuilt u-boot did you use the mityarm335x_4kpage config? - MF 08:53 AM Software Development: RE: Create ubifs
- From that page: