Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)

09/24/2018

TI 11:30 AM Software Development: RE: kernel panic on virtual machine start

Vivek
Your best bet is the following:
Rename the existing VM
Re-import the VM from the ova image
Go in to settings for the newly imported VM and add your existing VM disk image to the new VM
mount the old VM image in your new VM as ... Tim Iskander

09/23/2018

VP 09:06 AM Software Development: kernel panic on virtual machine start

Hi,
I had setup of virtual machine with Critical_Link_Unified_VM_14-04_04-2017.ova image. Something went wrong with sudo tar xzvf command in root directory. After that VM stop responding. I powered off virtual machine. When I tried to r... Vivek Ponnani

09/14/2018

JC 01:32 PM Software Development: RE: Yocto MDK Status

Thanks Tom. Jonathan Cormier

TR 12:40 AM Software Development: RE: Yocto MDK Status

FYI... have made the following changes to the recipes as to update fetching the proper sources. For vim it's a different URL and for ltrace it just needed a branch designation. Someone may find them useful. Tom
Tom Riddle

08/29/2018

TR 11:06 PM Software Development: RE: Yocto MDK Status

Hi, well it was easier then trying to fix the two repo failures, (which I will do)... just running bitbake again without the -k saw it succeed and now have the jffs image. Tom Tom Riddle

JC 10:04 PM Software Development: RE: Yocto MDK Status

Tom Riddle wrote:
> Hi Jonathan,
> ... Jonathan Cormier

TR 07:36 PM Software Development: RE: Yocto MDK Status

Hi Jonathan,
We open a shell, go to yocto-archives dir, set the env
> source oe-init-build-env
then execute
> ...
to bypass the two repos that are not available. Please see the attached gzip file of the log. Let me know what... Tom Riddle

08/28/2018

JC 06:21 PM Software Development: RE: Yocto MDK Status

Could you provide a log of your bitbake command plus output in an attached file? Jonathan Cormier

TR 06:10 PM Software Development: RE: Yocto MDK Status

Hi Folks... any feedback on where the image might be? Thanks, Tom Tom Riddle

AB 03:18 PM PCB Development: RE: OMAP L138 HPI

Unfortunately during my initial review of the modules with and without FPGA I confused the RESETOUT (T17) pin connection for the FPGA module.
As you have found T17 from the L138 is not connected to an FPGA IO but is connected to a ded... Alexander Block

HS 09:05 AM PCB Development: RE: OMAP L138 HPI

Thank you.
I was able to check the connection information between FPGA and L138.
Could you tell me the pin wiring of ball T17(UHPI_HAS) of L138?
It seems necessary to connect to power supply(1.8V or 3.3V). Hisato Seki