Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)

09/23/2018

VP 09:06 AM Software Development: kernel panic on virtual machine start

Hi,
I had setup of virtual machine with Critical_Link_Unified_VM_14-04_04-2017.ova image. Something went wrong with sudo tar xzvf command in root directory. After that VM stop responding. I powered off virtual machine. When I tried to r... Vivek Ponnani

09/14/2018

JC 01:32 PM Software Development: RE: Yocto MDK Status

Thanks Tom. Jonathan Cormier

TR 12:40 AM Software Development: RE: Yocto MDK Status

FYI... have made the following changes to the recipes as to update fetching the proper sources. For vim it's a different URL and for ltrace it just needed a branch designation. Someone may find them useful. Tom
Tom Riddle

08/29/2018

TR 11:06 PM Software Development: RE: Yocto MDK Status

Hi, well it was easier then trying to fix the two repo failures, (which I will do)... just running bitbake again without the -k saw it succeed and now have the jffs image. Tom Tom Riddle

JC 10:04 PM Software Development: RE: Yocto MDK Status

Tom Riddle wrote:
> Hi Jonathan,
> ... Jonathan Cormier

TR 07:36 PM Software Development: RE: Yocto MDK Status

Hi Jonathan,
We open a shell, go to yocto-archives dir, set the env
> source oe-init-build-env
then execute
> ...
to bypass the two repos that are not available. Please see the attached gzip file of the log. Let me know what... Tom Riddle

08/28/2018

JC 06:21 PM Software Development: RE: Yocto MDK Status

Could you provide a log of your bitbake command plus output in an attached file? Jonathan Cormier

TR 06:10 PM Software Development: RE: Yocto MDK Status

Hi Folks... any feedback on where the image might be? Thanks, Tom Tom Riddle

AB 03:18 PM PCB Development: RE: OMAP L138 HPI

Unfortunately during my initial review of the modules with and without FPGA I confused the RESETOUT (T17) pin connection for the FPGA module.
As you have found T17 from the L138 is not connected to an FPGA IO but is connected to a ded... Alexander Block

HS 09:05 AM PCB Development: RE: OMAP L138 HPI

Thank you.
I was able to check the connection information between FPGA and L138.
Could you tell me the pin wiring of ball T17(UHPI_HAS) of L138?
It seems necessary to connect to power supply(1.8V or 3.3V). Hisato Seki