-1A to -2A corrected following issues:

    
   Issue discovered during debugging:

	1. J1 rotated 180 degrees. As a result pin assignments for J1 symbol were not correct (needed mirroring). The even and odd pins for J1 were jumpered (mirrored) to correctly mate to the Industrial I/O board. Connections were made as following:
    	DACSCLK/ADCSCK -> Pin 12 (CAN_CLK)
    	ADCDATA/DACSDI -> pin 14 (CAN_SIMO)
    	DACSYNC -> pin 20 (GPIO0_15)
    	ADCRESET -> pin 19 (GPIO0_5)
    	ADCCS -> pin 22 (GPIO0_6)

This was corrected in layout.

	2. J4 rotated 180 degrees. Same as issue #1.

This was corrected in layout.

    	3. Added parts to implement filter on the output of 100/200Mhz DAC

    	4. RESET and PWRDN are pulled up.
	