|
Linux version 2.6.34-rc1 (zoltan@zoltandev) (gcc version 4.5.1 (Sourcery G++ Lit
|
|
e 2010.09-50) ) #4 PREEMPT Wed Jun 29 15:56:42 CDT 2011
|
|
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
|
|
CPU: VIVT data cache, VIVT instruction cache
|
|
Machine: MityDSP-L138
|
|
Peripheral Config Block Found
|
|
Enet_Config = 2
|
|
PHYMask = 0x8
|
|
No LCD Configured
|
|
UART[0] = 0, 0, 0, 115200
|
|
UART[1] = 1, 1, 0, 115200
|
|
UART[2] = 0, 0, 0, 115200
|
|
SPI[0] = 0, 0, 00, 0, 0
|
|
SPI[1] = 1, 1, 01, 0, 30000000
|
|
Memory policy: ECC disabled, Data cache writethrough
|
|
On node 0 totalpages: 12288
|
|
free_area_init_node: node 0, pgdat c035a41c, node_mem_map c0386000
|
|
DMA zone: 96 pages used for memmap
|
|
DMA zone: 0 pages reserved
|
|
DMA zone: 12192 pages, LIFO batch:1
|
|
DaVinci da850/omap-l138 variant 0x0
|
|
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 12192
|
|
Kernel command line: mem=48M console=ttyS1,115200n8 root=/dev/ram0 rw initrd=0xc
|
|
1180000,16M
|
|
PID hash table entries: 256 (order: -2, 1024 bytes)
|
|
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
|
|
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
|
|
Memory: 48MB = 48MB total
|
|
Memory: 28724k/28724k available, 20428k reserved, 0K highmem
|
|
Virtual kernel memory layout:
|
|
vector : 0xffff0000 - 0xffff1000 ( 4 kB)
|
|
fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
|
|
DMA : 0xff000000 - 0xffe00000 ( 14 MB)
|
|
vmalloc : 0xc3800000 - 0xfea00000 ( 946 MB)
|
|
lowmem : 0xc0000000 - 0xc3000000 ( 48 MB)
|
|
modules : 0xbf000000 - 0xc0000000 ( 16 MB)
|
|
.init : 0xc0008000 - 0xc0025000 ( 116 kB)
|
|
.text : 0xc0025000 - 0xc0320000 (3052 kB)
|
|
.data : 0xc0338000 - 0xc035ae40 ( 140 kB)
|
|
Experimental preemptable hierarchical RCU implementation.
|
|
NR_IRQS:373
|
|
Console: colour dummy device 80x30
|
|
Calibrating delay loop... 149.50 BogoMIPS (lpj=747520)
|
|
Mount-cache hash table entries: 512
|
|
CPU: Testing write buffer coherency: ok
|
|
DaVinci: gpio irqs disabled on bank 6
|
|
DaVinci: 144 gpio irqs
|
|
regulator: core version 0.5
|
|
NET: Registered protocol family 16
|
|
mityomapl138_init...
|
|
mityomapl138_setup_nand: using 16 bit data
|
|
EMAC: MII PHY configured, RMII PHY will not be functional
|
|
mityomapl138_init: setting phy_mask to 8
|
|
bio: create slab <bio-0> at 0
|
|
SCSI subsystem initialized
|
|
usbcore: registered new interface driver usbfs
|
|
usbcore: registered new interface driver hub
|
|
usbcore: registered new device driver usb
|
|
regulator: VDCDC1: 1150 <--> 1350 mV at 1200 mV
|
|
regulator: VDCDC2: 1710 <--> 1910 mV at 3300 mV
|
|
regulator: VDCDC3: 1120 <--> 1320 mV at 1800 mV
|
|
regulator: LDO1: 1800 mV
|
|
regulator: LDO2: 3300 mV
|
|
Switching to clocksource timer0_1
|
|
NET: Registered protocol family 2
|
|
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
|
|
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
|
|
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
|
|
TCP: Hash tables configured (established 2048 bind 2048)
|
|
TCP reno registered
|
|
UDP hash table entries: 256 (order: 0, 4096 bytes)
|
|
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
|
|
NET: Registered protocol family 1
|
|
RPC: Registered udp transport module.
|
|
RPC: Registered tcp transport module.
|
|
RPC: Registered tcp NFSv4.1 backchannel transport module.
|
|
Trying to unpack rootfs image as initramfs...
|
|
rootfs image is not initramfs (no cpio magic); looks like an initrd
|
|
Freeing initrd memory: 16384K
|
|
JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
|
|
msgmni has been set to 88
|
|
io scheduler noop registered (default)
|
|
Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled
|
|
serial8250.0: ttyS0 at MMIO 0x1c42000 (irq = 25) is a 16550A
|
|
serial8250.0: ttyS1 at MMIO 0x1d0c000 (irq = 53) is a 16550A
|
|
console [ttyS1] enabled
|
|
serial8250.0: ttyS2 at MMIO 0x1d0d000 (irq = 61) is a 16550A
|
|
brd: module loaded
|
|
at24 1-0050: 256 byte 24c02 EEPROM (read-only)
|
|
MityOMAPL138: Found MAC = 00:50:c2:bf:89:05
|
|
MityOMAPL138: Part Number = L138-CG-225-RC
|
|
MityOMAPL138: setting max frequency to 300 MHz
|
|
NAND device: Manufacturer ID: 0x2c, Chip ID: 0xca (Micron NAND 256MiB 3,3V 16-bi
|
|
t)
|
|
Bad block table found at page 131008, version 0x01
|
|
Bad block table found at page 130944, version 0x01
|
|
nand_bbt: ECC error while reading bad block table
|
|
nand_read_bbt: Bad block at 0x000009100000
|
|
Creating 2 MTD partitions on "davinci_nand.1":
|
|
0x000000000000-0x000008000000 : "rootfs"
|
|
0x000008000000-0x000010000000 : "homefs"
|
|
davinci_nand davinci_nand.1: controller rev. 2.5
|
|
spi_davinci spi_davinci.1: DMA: supported
|
|
spi_davinci spi_davinci.1: DMA: RX channel: 18, TX channel: 19, event queue: 0
|
|
spi_davinci spi_davinci.1: registered master spi1
|
|
spi spi1.0: setup mode 0, 8 bits/w, 30000000 Hz max --> 0
|
|
m25p80 spi1.0: m25p64 (8192 Kbytes)
|
|
Creating 8 MTD partitions on "m25p80":
|
|
0x000000000000-0x000000010000 : "ubl"
|
|
0x000000010000-0x000000090000 : "u-boot"
|
|
0x000000090000-0x0000000a0000 : "u-boot-env"
|
|
0x0000000a0000-0x0000000b0000 : "periph-config"
|
|
0x0000000b0000-0x000000100000 : "reserved"
|
|
0x000000100000-0x000000400000 : "kernel"
|
|
0x000000400000-0x000000600000 : "fpga"
|
|
0x000000600000-0x000000800000 : "spare"
|
|
spi_davinci spi_davinci.1: registered child spi1.0
|
|
spi_davinci spi_davinci.1: Controller at 0xfef0e000
|
|
console [netcon0] enabled
|
|
netconsole: network logging started
|
|
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
|
|
ohci ohci.0: DA8xx OHCI
|
|
ohci ohci.0: new USB bus registered, assigned bus number 1
|
|
Waiting for USB PHY clock good...
|
|
ohci ohci.0: irq 59, io mem 0x01e25000
|
|
hub 1-0:1.0: USB hub found
|
|
hub 1-0:1.0: 1 port detected
|
|
omap_rtc omap_rtc: rtc core: registered omap_rtc as rtc0
|
|
omap_rtc: RTC power up reset detected
|
|
omap_rtc: already running
|
|
i2c /dev entries driver
|
|
cpuidle: using governor ladder
|
|
cpuidle: using governor menu
|
|
TCP cubic registered
|
|
NET: Registered protocol family 17
|
|
Clocks: disable unused i2c1
|
|
Clocks: disable unused emac
|
|
Clocks: disable unused mcasp
|
|
Clocks: disable unused lcdc
|
|
Clocks: disable unused mmcsd
|
|
Clocks: disable unused spi0
|
|
Clocks: disable unused mcbsp0
|
|
Clocks: disable unused mcbsp1
|
|
Clocks: disable unused vpif
|
|
Clocks: disable unused ecap
|
|
Clocks: disable unused ehrpwm
|
|
regulator_init_complete: incomplete constraints, leaving LDO2 on
|
|
regulator_init_complete: incomplete constraints, leaving LDO1 on
|
|
regulator_init_complete: incomplete constraints, leaving VDCDC3 on
|
|
regulator_init_complete: incomplete constraints, leaving VDCDC2 on
|
|
regulator_init_complete: incomplete constraints, leaving VDCDC1 on
|
|
emac-mii: probed
|
|
omap_rtc omap_rtc: setting system clock to 2000-01-06 01:06:30 UTC (947120790)
|
|
RAMDISK: gzip image found at block 0
|
|
VFS: Mounted root (ext2 filesystem) on device 1:0.
|
|
Freeing init memory: 116K
|
|
eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=1:03, id=40005201)
|
|
PHY: 1:03 - Link is Up - 100/Full
|