|
Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled
|
|
serial8250.0: ttyS0 at MMIO 0x1c42000 (irq = 25) is a 16550A
|
|
serial8250.0: ttyS1 at MMIO 0x1d0c000 (irq = 53) is a 16550A
|
|
console [ttyS1] enabled
|
|
serial8250.0: ttyS2 at MMIO 0x1d0d000 (irq = 61) is a 16550A
|
|
brd: module loaded
|
|
at24 1-0050: 256 byte 24c02 EEPROM, read-only, 0 bytes/write
|
|
MityOMAPL138: Found MAC = 00:50:c2:bf:8d:b3
|
|
MityOMAPL138: Part Number = 1810-DG-225-RC
|
|
ahci ahci: forcing PORTS_IMPL to 0x1
|
|
ahci ahci: AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl platform mode
|
|
ahci ahci: flags: ncq sntf pm led clo only pmp pio slum part ccc
|
|
scsi0 : ahci_platform
|
|
ata1: SATA max UDMA/133 mmio [mem 0x01e18000-0x01e19fff] port 0x100 irq 67
|
|
NAND device: Manufacturer ID: 0x2c, Chip ID: 0xca (Micron NAND 256MiB 3,3V 16-bit)
|
|
Bad block table found at page 131008, version 0x01
|
|
Bad block table found at page 130944, version 0x01
|
|
Creating 2 MTD partitions on "davinci_nand.1":
|
|
0x000000000000-0x000008000000 : "rootfs"
|
|
0x000008000000-0x000010000000 : "homefs"
|
|
davinci_nand davinci_nand.1: controller rev. 2.5
|
|
spi_davinci spi_davinci.1: DMA: supported
|
|
spi_davinci spi_davinci.1: DMA: RX channel: 18, TX channel: 19, event queue: 0
|
|
m25p80 spi1.0: m25p64-nonjedec (8192 Kbytes)
|
|
Creating 8 MTD partitions on "m25p80":
|
|
0x000000000000-0x000000010000 : "ubl"
|
|
0x000000010000-0x000000090000 : "u-boot"
|
|
0x000000090000-0x0000000a0000 : "u-boot-env"
|
|
0x0000000a0000-0x0000000b0000 : "periph-config"
|
|
No LCD configured
|
|
MII PHY configured
|
|
0x0000000b0000-0x000000100000 : "reserved"
|
|
0x000000100000-0x000000400000 : "kernel"
|
|
0x000000400000-0x000000600000 : "fpga"
|
|
0x000000600000-0x000000800000 : "spare"
|
|
spi_davinci spi_davinci.1: Controller at 0xfef0e000
|
|
CAN device driver interface
|
|
mcp251x spi1.1: probed
|
|
davinci_mdio davinci_mdio.0: davinci mdio revision 1.5
|
|
davinci_mdio davinci_mdio.0: detected phy mask fffffff7
|
|
davinci_mdio.0: probed
|
|
davinci_mdio davinci_mdio.0: phy[3]: device 0:03, driver unknown
|
|
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
|
|
ohci ohci.0: DA8xx OHCI
|
|
ohci ohci.0: new USB bus registered, assigned bus number 1
|
|
Waiting for USB PHY clock good...
|
|
ohci ohci.0: irq 59, io mem 0x01e25000
|
|
ata1: SATA link down (SStatus 0 SControl 300)
|
|
hub 1-0:1.0: USB hub found
|
|
hub 1-0:1.0: 1 port detected
|
|
Initializing USB Mass Storage driver...
|
|
usbcore: registered new interface driver usb-storage
|
|
USB Mass Storage support registered.
|
|
mousedev: PS/2 mouse device common for all mice
|
|
omap_rtc omap_rtc: rtc core: registered omap_rtc as rtc0
|
|
omap_rtc: RTC power up reset detected
|
|
omap_rtc: already running
|
|
i2c /dev entries driver
|
|
cpuidle: using governor ladder
|
|
cpuidle: using governor menu
|
|
davinci_mmc davinci_mmc.0: Using DMA, 4-bit mode
|
|
usbcore: registered new interface driver usbhid
|
|
usbhid: USB HID core driver
|
|
dsd1791 spi1.2: Failed to add route LLOUT->Line Out
|
|
asoc: dsd1791 <-> davinci-mcasp.0 mapping ok
|
|
ALSA device list:
|
|
#0: MityDSP-L138 INDIO
|
|
TCP cubic registered
|
|
NET: Registered protocol family 17
|
|
can: controller area network core (rev 20090105 abi 8)
|
|
NET: Registered protocol family 29
|
|
can: raw protocol (rev 20090105)
|
|
regulator_init_complete: LDO2: incomplete constraints, leaving on
|
|
regulator_init_complete: LDO1: incomplete constraints, leaving on
|
|
regulator_init_complete: VDCDC3: incomplete constraints, leaving on
|
|
regulator_init_complete: VDCDC2: incomplete constraints, leaving on
|
|
regulator_init_complete: VDCDC1: incomplete constraints, leaving on
|
|
console [netcon0] enabled
|
|
netconsole: network logging started
|
|
omap_rtc omap_rtc: setting system clock to 2000-01-01 00:30:27 UTC (946686627)
|
|
List of all partitions:
|
|
1f00 131072 mtdblock0 (driver?)
|
|
1f01 131072 mtdblock1 (driver?)
|
|
1f02 64 mtdblock2 (driver?)
|
|
1f03 512 mtdblock3 (driver?)
|
|
1f04 64 mtdblock4 (driver?)
|
|
1f05 64 mtdblock5 (driver?)
|
|
1f06 320 mtdblock6 (driver?)
|
|
1f07 3072 mtdblock7 (driver?)
|
|
1f08 2048 mtdblock8 (driver?)
|
|
1f09 2048 mtdblock9 (driver?)
|
|
No filesystem could mount root, tried: ext3 ext2 cramfs vfat msdos
|
|
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,0)
|
|
[<c000d518>] (unwind_backtrace+0x0/0xe0) from [<c0323c4c>] (panic+0x58/0x188)
|
|
[<c0323c4c>] (panic+0x58/0x188) from [<c052dbf4>] (mount_block_root+0x1bc/0x1fc)
|
|
[<c052dbf4>] (mount_block_root+0x1bc/0x1fc) from [<c052ddcc>] (mount_root+0xa0/0xc0)
|
|
[<c052ddcc>] (mount_root+0xa0/0xc0) from [<c052df48>] (prepare_namespace+0x15c/0x1bc)
|
|
[<c052df48>] (prepare_namespace+0x15c/0x1bc) from [<c052d858>] (kernel_init+0xe8/0x11c)
|
|
[<c052d858>] (kernel_init+0xe8/0x11c) from [<c0009cb8>] (kernel_thread_exit+0x0/0x8)
|
